TM9-2330-358-14&P
(7) Slide new shell (3) on wire lead (l). Apply insulating compound to wire
lead (l).
(8) Slide wire lead end (1) into new contact (4), and using crimping tool,
crimp.
(9) Place new retaining washer (5) on lead (1) at contact (4).
(lo) Slide shell (3) down wire lead (1) until retaining washer (5) seats.
Push connector (2)
(11) Apply insulating compound to outside of connector (2).
halves together until seated.
Turn on semitrailer lights and check for proper operation.
(12) Connect power.
b.
Female Connector Repair.
(2) Slide shell (4) and sleeve (6) up wire lead (3) until clear of terminal
(5).
Be sure
(3) Using diagonal cutting pliers, cut terminal (5) off wire lead (3).
to leave enough lead for connection after repair.
Discard shell (4) and
(4) Slide shell (4) and sleeve (6) off wire lead (3).
sleeve (6).
(5) Using wire stripper, strip insulation from wire lead (3) l/8-inch (3.2 mm)
from end.
(6) Slide new shell (4) and sleeve (6) on wire lead (3). Apply insulation
compound to end of wire lead (3).
Female Connector Repair
Figure 4-16.
4-39