(1) Install new lining (2, fig. 5-7) on brake shoes (4).
(2) Align rivet holes (5) in brake shoe (4) and lining (2 and 3). Clamp
linings in place.
(3) Install end rivets (1) in lining (2 and 3). Remove clamp and install
remaining rivets (l).
(4) Check contact of linings (2 and 3) with brake shoe (4) after riveting. A
0.010 inch feeler gage should not enter between brake shoe (4) and lining
(2 and 3) at any point.
TASK ENDS HERE
M A I N T E N A N C E OF THE WHEELS, HUBS AND DRMS
This task covers:
Lathe, brake drum
General mechanics tool kit and common supplement II