TM9-2330-368-14
P
2-28. OPERATION WITH SPLL ADAPTER
If it is necessary to tow the HEMAT with a SPLL
vehicle, the SPLL adapter must be attached to the
tongue of the trailer to allow additional clearance
between the towing vehicle and trailer. All other
operational procedures are the same as those
a. SPLL Adapter Installation.
(1) Remove one hex nut (1) and cap) screw
(2) to detach SPLL adapter from inside
tool box.
(2) Remove three hex nuts ( 1), four lock
washers (4) and three cap screws (2)
from slot (5) in SPLL adapter (3).
(3) Attach SPLL adapter (3) under tongue
(6) with four hex nuts (1), lock washers
(4) and cap screws (2). Tighten hex
nuts.
( 4 ) Push trailer parking brake control knob
(7) to release parking brakes.
b. Removal of SPLL Adapter.
(1) Remove four hex nuts (1), lock washers
(4) and cap screws (2) to detach SPLL
adapter (3) from underside of trailer
tongue (6).
(2) Install three hex nuts ( 1), four lock
washers (4) and three cap screws (2)
in slot (5) in SPLL adapter (3).
(3) Fasten SPLL adapter (3) to trailer
frame in tool box with one hex nut
(1) and cap screw (2). Tighten hex nut.
2-29. FRESH WATER FORDING
Maximum fording depth of the HEMAT is 48
inches. No special maintenance is required.
TA252 158
2-29/(2-30 Blank)