TM9-2330-368-14 & P
Section VIII. MAINTENANCE OF FRAME AND TOWING COMPONENTS
Page
Page
Landing Gear . . . . . . . . . . . . . . . . . . . . . . . . 4-49
Bumpers . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-46
Coupler . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-46
Storage Box Cover . . . . . . . . . . . . . . . . . . 4-50
Pod Stops . . . . . . . . . . . . . . . . . . . . . . . . . 4-50
Safety Chains . . . . . . . . . . . . . . . . . . . . . . . . 4-47
Lifting Eyes . . . . . . . . . . . . . . . . . . . . . . . . . . 4-47
Spare Tire Carrier . . . . . . . . . . . . . . . . . . . . 4-48
4-24. BUMPERS
Materials/Tools
General mechanics tool kit
Torque wrench, 3/8 inch drive, 0-150 lb-ft.
Socket, 3/4 inch, 3/8 inch drive
a. Removal. Remove two hex nuts (1), lock
washers (2), cap screws (3), flat washers (4)
to remove each of two bumpers (5).
b. Installation. Install each bumper (5) with
two cap screws (3), flat washers (4), lock
washers (2) and hex nuts (1). Tighten hex
nut to 35 lb-ft.
4-25. COUPLER
Materials/Tools
General mechanics tool kit
Four lock washers, 3/4 inch
Torque wrench, 3/4 inch drive, 0-600 lb-ft.
Socket, 1-1/8 inch, 3/4 inch drive
a. Removal. Remove four hex nuts (1), lock
washers (2), cap screws (3) and coupler (4).
Discard lock washers.
b. Installation. Mount coupler (4) on frame
with four cap screws (3), new lock washers
(2) and hex nuts (1). Tighten hex nuts to
300 lb-ft.
Change 1
4-46