TM 9-2330-371-14&P
COMPOSITE LIGHT ADAPTER HARNESS - CONTINUED
ACTION
ITEM
REMARKS
LOCATION
REMOVAL - CONTINUED
NOTE
Some harness clamps hold both the composite light
adapter harness and the main wire harness. Record
locations for installation.
Using 7/16-inch socket and handle, un-
Five nuts (3) and
Wire harness (1)
2.
screw and take off.
Iockwashers (4)
and five studs (2)
Spread and take off.
Five harness
Wire harness (1)
3.
clamps (5)
Pull out and take off harness (1).
Grommet (8)
Grommet hole (6)
4.
in left main
frame (7)
a. Check wire markers for readability.
14 connector
Left composite
5.
If not readable, tag for assembly.
halves (11)
light leads (9),
b. Pull apart halves.
main wire harness
(1), and adapter
harness (10)
16 connector
a. Check wire markers for readability.
Right composite
6.
halves (13)
If not readable, tag for assembly.
light leads (12),
b. Pull apart halves.
main wire harness
(1) and adapter
harness (10)
Adapter harness (10)
Feed through holes to center of semi-
Two grommet
7.
trailer between main frames, and take out.
holes (6)
It may be necessary to pull main wire
and (14)
harness connector halves through left
main frame to remove adapter harness.
INSTALLATION
a. From center of semitrailer
Adapter harness (10)
Two grommet
8.
feed to left and right side.
holes (6)
Adapter harness end with eight con-
and (14)
nector halves goes to right side.
b. Feed main wire harness connector
halves through left main frame.