TM 9-2330-371-14&P
LANDING GEAR CRANK AND CRANK HOLDER - CONTINUED
ACTION
REMARKS
ITEM
LOCATION
INSTALLATION
Put capscrew (2) through washer (3) and
Capscrew (2)
Crank holder (1)
5.
crank holder (1).
and washer (3)
Put through hole in leg (4).
Capscrew (2)
Landing gear
6.
leg (4)
Put on and tighten using 15/16-inch
Nut (5) and
Capscrew (2)
7.
socket, handle, and 15/16-inch wrench.
washer (6)
Put on gearbox shaft (9) and line up
Handcrank (8)
Gearbox (7)
8.
boltholes.
Put through crank (8) and shaft (9) and
Capscrew (10), two
Handcrank (8)
9.
tighten using 9/16-inch socket, handle,
washers (11), and
and 9/16-inch wrench.
nut (12)
One washer goes on each side of
crank.
TASK ENDS HERE
TA224298