TM 9-2330-371-14&P
BRAKEDRUM REPAIR - CONTINUED
ACTION
ITEM
LOCATION
REMARKS
REPAIR - CONTINUED
CAUTION
If turning causes the drum to exceed the original
diameter by more than 0.060 inch (1.52 mm), you
will have to replace the drum. Whenever the drum on
one side of the axle is refinished, the other drum on
that axle should be turned to the same specifications.
Inner braking
a. Refinish by turning, using refinishing
Brakedrum (1)
5.
lathe.
surface (2)
b. Make several thin cuts until scoring or
grooving defects have been removed.
Check the drum diameter after each
cut, to make sure you have not cut
too much metal out. See caution
above.
c. Refinish mating drum to same specifica-
tions as the one above.
NOTE
FOLLOW-ON
MAINTENANCE:
TASK ENDS HERE
TA224324
5-18