TM 9-2330-371-14&P
SPRING SEAT - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
INSTALLATION CONTINUED
Trunnion tube
Lockwasher (6)
23.
a. Slide over trunnion tube shaft (5)
shaft (5)
with tab (7) in keyway (8).
Bump on adjusting hex nut (4) should
aline to hole in Iockwasher (6).
b. Aline bump on adjusting nut (4) to lock-
washer (6) hole by turning adjusting nut (4)
to the right with wheel nut wrench.
Outer hex
24.
Screw on and tighten with wheel nut
nut (9)
wrench.
Gasket (10)
Spring seat
25.
a. Place on spring seat (1), and aline to
and cover (11)
assembly (1)
capscrew holes (12).
b. Secure cover (11) to spring seat (1)
with six washers (13) and capscrews
(14), and tighten using 1/2-inch
wrench.
NOTE
FOLLOW-ON
MAINTENANCE:
TASK ENDS HERE