TM 9-2330-373-14 & P
4-13.
MARKER CLEARANCE LIGHT (cont)
REMOVAL
1.
Remove two screws (1) and remove
lens (2).
2.
Remove two screws (4) securing
light.
3.
Remove insert (7) from rear of
light body.
4.
Pull wire (5) away from contact
points (6) and remove light.
1.
Screw
5. Wire
2.
Lens
6. Contact points
4.
Screw
7. Insert
CLEANING AND INSPECTION
WARNING
Cleaning solvent, used to clean parts, is potentially dangerous to personnel and property. Do not use near
open flame or excessive heat. Flash point of solvent is 158 F (58.8 C).
1.
Clean all parts, except rubber items or gaskets, with cleaning solvent (item 3, appendix E).
2.
Inspect body for cracks, warpage, cracked or broken lens, or evidence of leakage.
3.
Make sure all parts are in good condition and will make good electrical contact and watertight connections.
INSTALLATION
1.
Place wire (5) over two contact points (6) on rear of light.
2.
Position insert (7) and press down to compress wire against contact points and provide electrical contact.
3.
Secure light with two screws (4).
4.
Position lens (2) and secure with two screws (1).
TA 314767
4-46