TM 9-2330-376-14&P
2-6. GENERAL PMCS PROCEDURES (Con't).
b. While performing specific PMCS procedures, inspect the following components:
(1) Bolts, Nuts, and Screws. Ensure that they are not loose, missing, bent, or broken. Report loose or
missing bolts, nuts, and screws to Organizational Maintenance.
(2) Welds. Inspect for gaps where parts are welded together. Check for loose or chipped paint, rust, and
cracks. Report bad welds to Organizational Maintenance.
(3) Electric Conduit, Wires, or Connectors. Inspect for cracked or broken conduit insulation, bare
wires, and loose or broken connectors. Report loose connections and faulty wiring to Organizational Maintenance.
(4) Hoses, Lines, and Fittings. Inspect for wear, damage, and leaks. Ensure that clamps and fittings are
tight. Report any damage, leaks, or loose fittings and clamps to Organizational Maintenance.
2-7. SPECIFIC PMCS PROCEDURES.
a. Operator/crew PMCS are provided in Table 2-1. Always perform PMCS in the order listed, Once it becomes
a habit, anything that is not right can be spotted in a minute.
b. Before performing PMCS, read all the checks required for the applicable interval and prepare all the tools
needed. Have several clean rags (item 12, Appendix E) handy. Perform ALL inspections at the applicable interval.
c. if anything wrong is discovered through PMCS, perform the appropriate troubleshooting task in Chapter 3,
Section II. if
any component or
system is
not serviceable, or if a
given service does not correct the problem, notify your
supervisor.
d. The columns in Table 2-1 are defined as follows:
(1) Item No. Provides a logical sequence for PMCS to be performed and is used as a source of item
numbers for the "TM ITEM NO" column when recording PMCS results on DA Form 2404.
(2) Interval. Specifies the interval at which PMCS is to be performed.
(3) Item to be Inspected. Lists the system and common name of items that are to be inspected.
Included in this column are specific servicing, inspection, replacement, or adjustment procedures to be followed.
NOTE
The terms "ready/available" and "mission-capable" refer to the same status: equipment
is on hand and is able to perform its combat missions (AR 700-138).
(4) Equipment is Not/Ready Available If: Explains when the trailer is nonmission-capable.
2-8. LEAKAGE DEFINITIONS.
a. It is important to know how fluid leakage affects the status of the trailer. Following are types/classes of
leakage an operator must know to determine whether the trailer is mission-capable. Learn these leakage definitions.
When in doubt, notify your supervisor.
Leakage Definitions for Operator/Crew PMCS
Class I
Seepage of fluid (as indicated by wetness or discoloration) not
great enough to form drops.
Class II
Leakage of fluid great enough to form drops, but not great enough
to cause drops to drip from item being inspected.
Leakage of fluid great enough to form drops that fall from item being
Class IlI
inspected.
2-4