TM9-2330-376-14&P
7.
Remove four nuts (7), Iockwashers (6), eight flatwashers (3 and 5), and four screws (2). Remove air reservoir (1)
from two brackets (4). Discard Iockwashers.
8.
Remove three studs (17) and plug (18) from air reservoir (1).
INSTALLATION
b.
NOTE
Apply antiseizing tape to all male threads.
1.
Install plug (18) and three studs (17) in air reservoir (1).
2.
Install air reservoir (1) on two brackets(4) with four screws (2), eight flatwashers (3 and 5), four new Iockwashers
(6), and nuts (7).
Install draincock (16) in air reservoir(1).
3.
4.
Install wire rope (15) in tube assembly (10). Slide ball end(8) and handle (9) onto wire rope. Firmly crimp ball end
and press into handle.
Install spring (11) and retainer (13) on wire rope
5.
(15). Loosely install setscrew (12) in retainer. Draw
wire rope tight and conpress spring so that 5/8 in.
(16 mm) is between retainer and end of tube
assembly (10). Tighten setscrew.
6.
Slide clamp (14) onto wire rope (15).
7.
Loop wire rope (15) through draincock (16) and secure with clamp (14).
FOLLOW-ON TASKS:
Use a soap solution to check for leaks. No leaks are permissible.
TA700975
4-75