M - Monthly
Y - 5 Years
UPPER SUSPENSION BEARINGS AND UPPER AND LOWER CYLINDER BEARINGS, S-CAM RETAINER,
S-CAM BUSHING, SLACK ADJUSTER, AND SUSPENSION PIVOT PINS. Monthly lubricate upper suspension bearings
and upper and lower cylinder bearings, S-cam retainers, S-cam bushings, slack adjuster, and suspension pivot pins.
Clean surrounding areas and all fittings. DO NOT OVERFILL. Apply grease (GAA) to upper suspension assembly and
upper and lower cylinder bearings, brake camshafts, and suspension pivot pin fittings as required and wipe off excess
with rag. The suspension pivot pin has two fittings which service the same piece. If fully serviced through one fitting, the
other fitting will appear to not take grease. Deck must be in lowest position to lubricate brake camshaft and S-cam
UPPER AND LOWER STEERING PLATE BEARINGS. Every 5 years remove, clean, and hand or pressure pack
upper and lower steering plate bearings. Clean any existing grease from bearings and steering plates. Hand pack or
pressure pack bearings with grease (GAA) and wipe off excess with rag.
Change 3 3-15