If two ring spacer assemblies (34) have fallen, pick up and discard ring spacer assemblies.
Cut and remove electrical tiedown straps (24) from loon (25). Remove skid assembly (29) from loom (25).
The ends of each hydraulic hose connected to the suspension cylinder line
fracture valve do not have swivel fittings. During removal, each entire hose must
be turned counterclockwise at the same rate the end fitting is turned or damage to
equipment may result.
Using on person to loosen each hose and one person to turn each hose (5) counterclockwise, tag and disconnect
two hydraulic hoses (5) from line fracture valve (35).
Remove two hydraulic hoses (5) from bogie. Measure and document hole in loom (25) for skid assembly.
Remove loon (25) from both hydraulic hoses (5).