TM 9-2330-383-14&P
4-11. COMPOSITE LIGHTS (CONT)
(3)
If defective, replace stop lamp assembly (16) by using a small
screwdriver and inserting it on left side (facing taillight) between
printed wiring board and printed wiring board housing. Pop open printed
wiring board and insert screwdriver in screw (17) slot in the middle of
printed wiring board housing. Press down and turn screw (17)
counterclockwise to remove bayonet (18) and stop lamp assembly (16)
from socket.
(4)
Replace stop lamp assembly (16), with printed wiring board popped open,
by positioning bayonet (18) in socket and using small screwdriver in
screw (17) slot. Press down and turn screw (17) clockwise until bayonet
(18) is seated in socket.
(5)
Snap shut printed wiring board into printed wiring board housing.
(6)
If defective, replace marker assembly (19) by using a small screwdriver
and inserting it in screw (20) slot in center of assembly. Press down
and turn screw (20) counterclockwise to remove bayonet (21) and
assembly (19) from socket.
CAUTION
Ensure wires are cleared from center screw (20) slot.
(7)
Replace marker assembly (19) by positioning bayonet (21) and assembly
(19) into socket. Using small screwdriver in screw (20) center slot,
press down and turn screw (20) clockwise until bayonet (21) is seated
in socket.
NOTE
Do not remove packing (22) unless damaged.
(8)
If necessary, replace packing (22). Install lens (13) into body (23)
and tighten and fasten six captive screws (12).
(9)
If necessary, replace housing (24) by drilling out eight rivets and
removing housing from trailer frame. Install housing (24) and eight
rivets.
Change 1