TM 9-2330-383-14&P
4-12. CLEARANCE MARKER LIGHTS
This task covers: a. Removal
b. Installation
INITIAL SETUP
Tools
General mechanics tool kit
For new trailers with serial numbers 2001 and up:
Portable electric drill 1/32-inch drill bit
Rivet gun kit
Materials/Parts
Lockwasher (4)
REMOVAL
NOTE
Old and new clearance marker lights are not interchangeable.
To remove clearance marker light from old trailers with serial numbers
2000 and below, perform step a. To remove clearance marker light from
new trailers with serial numbers 2001 and up, perform step b.
a. To remove clearance marker light (1) from old trailers with serial numbers
2000 and below, proceed as follows:
(1)
Remove two screws (2) and lens (3).
(2)
Remove lamp (4).
(3)
Remove grounding screw (5) and socket base (6) from mount plate (7) to
gain access to wiring.
(4)
Disconnect light connector from harness connector.
(5)
Push shell (8) back on wire and remove C-washer (9) and shell (8).
Remove terminal (10) if damaged.
NOTE
If removing center rear light, it will be necessary to drill or chisel
the fasteners, whether screws or rivets.
(6)
If necessary, remove existing fasteners, either four nuts (11),
lockwashers (12), washers (13), and screws (14) or four rivets (15),
mount plate (7), and gasket (16).
Change 1