TM 9-2330-383-14&P
4-12. CLEARANCE MARKER LIGHTS (CONT)
b. To remove clearance marker light (1) from new trailers with serial numbers
2001 and up, proceed as follows:
(1)
Disconnect electrical lead (17) and ground lead (18).
(2)
Remove two screws (19) and cover (20).
(3)
Remove four nuts (21), lockwashers (22), screws (23), washers (24),
light assembly (25), and gasket (26).
NOTE
The three red clearance marker lights in the rear center of the trailer
are mounted with rivets.
(4)
If removing rear center clearance marker light, use portable
drill with 7/32-inch drill bit and drill out four rivets.
(5)
Turn light emitting diode (LED) (27) one quarter turn counter-
clockwise (viewed from LED) and remove LED (27) from light
assembly (25).
(6)
If necessary, carefully lift connector (28) from LED (27).
INSTALLATION
NOTE
Old and new clearance marker lights are not interchangeable.
To install clearance marker light on new trailers with serial numbers
2001 and up, perform step a. To install clearance marker light on old
trailers with serial numbers 2000 and below, perform step b.
a. To install clearance marker light (1) on new trailers with serial numbers
2001 and up, proceed as follows:
(1)
Install connector (28) on LED (27).
(2)
Install LED (27) on light assembly (25) and turn one quarter turn
clockwise (viewed from LED).
(3)
Install gasket (26), light assembly (25), four washers (24), screws
NOTE
The three red clearance marker lights in the rear center of the trailer
are mounted with rivets.
(4)
If installing rear center clearance marker light, install four rivets
using a rivet gun kit.
(5)
Install cover (20) and two screws (19).
Change 1