TM 9-2330-383-14&P
4-17. CAMSHAFT (CONT)
INSTALLATION
NOTE
Two different thicknesses of washers are used on the camshaft, 0.30
inch and 0.60 inch thick. In addition, there is a thin washer that is
used to seal dirt out of the slack adjuster.
a. Install camshaft (2) through bracket (3).
b. Install inner camshaft (thin) washer (1) onto camshaft (2).
d. Check camshaft end play. Add or delete washers to obtain end play of 0.020
and 0.045 inch.
END OF TASK
This task covers: a. Removal
b. Installation
c. Brake Adjustment
INITIAL SETUP
Tools
Equipment Condition
General mechanics tool kit
Snap ring pliers
Materials/Parts
Cotter pin
REMOVAL
a. Remove cotter pin (1) and clevis pin (2) from air chamber push rod clevis
(3).
b. Using a 7/16-inch socket wrench, rotate slack adjuster hex (on underside of
slack adjuster (4)) counterclockwise (a ratcheting sound will be heard) until
slack adjuster arm is clear of push rod clevis (3).
4-34