TM 9-2330-383-14&P
c. Install inner and outer bearing cups (14 and 15) into hub (10), if removed.
d. Install inner bearing cone (11) and seal (12) into hub (10). Seal should have
word "airside" facing out of hub (10).
e. Install hub (10) onto spindle (13).
f. Install outer bearing (9), two washers (8) and nut (7).
WHEEL BEARING ADJUSTMENT
a. Tighten nut (7) to 50 lb ft while turning hub (10) in both directions. Back
off nut (7) 1/8 to 1/4 turn and check to see that there is no binding.
Install cotter pin (6).
b. Apply sealing compound to both sides of gasket (5), and install gasket (5),
hubcap (4) and six screws (3).
c. Install drum (2).
e. Lower trailer and remove chocks.
END OF TASK
Change 1
4-58.1