TM 9-2330-383-14&P
NOTE
Step e applies only to new trailers with serial numbers 2001 and up.
e. To remove hinge from door assembly, perform either step (1) or alternate
procedure step (2):
(1)
Use portable drill to remove eight rivets (17); then, remove hinge (18)
from door assembly (5).
(2)
(Alternate Procedure) Remove eight nuts (17.1), lockwashers (17.2), and
screws (17.3); then, remove hinge (18) from door assembly (5).
REPAIR
a. Replace defective parts as required.
b. Refer to appendix G for fabrication instructions for gaskets (15 and 16).
INSTALLATION
NOTE
Step a applies only to new trailers with serial numbers 2001 and up.
a. To install hinge to door assembly, perform either step (1) or alternate
procedure step (2):
(1)
Apply corrosion preventive compound to eight rivets (17) and to
surfaces where hinge (18) and door assembly (5) mate. Then, use rivet
gun to secure hinge (18) to door assembly (5) with eight rivets (17).
(2)
(Alternate Procedure) Secure hinge (18) to door assembly (5) with eight
a.1. Apply adhesive to two gaskets (16) and two gaskets (15) and install on door
assembly (5).
b. Install padlock assembly (14) and secure with screw (13), washer (12), and
lock nut (11).
c. Install handle (10) and secure with screw (9), two washers (8), and lock nut
(7).
d. Install mounting plate (6) and door assembly (5) and secure with six screws
(4), washers (3), lockwashers (2), and nuts (1).
END OF TASK
Change 1
4-75