GRABHANDLE AND CONVOY WARNING LIGHT CABLE ASSEMBLY REPAIR.
THIS TASK COVERS
Convoy Warning Light Cable Assembly
Grabhandle Cable Assembly Repair
Tool kit, general mechanic's
Tool kit, welder's
References: TM 9-237
a. GRABHANDLE CABLE ASSEMBLY REPAIR
(1) Remove two lockpins (3) from
grabhandle (2) and mounting
Cut cable (5) and remove. Retain
two lockpins (3) if not damaged.
Cut a length of new cable (5) 19
in. (48.3 cm) long.
Make two loops at ends of cable
(5) and install two sleeves (4).
Length of cable (5) and lockpin (3)
assembly should be 31 in. (78.7
Install two lockpins (3) through loops in cable (5). Pull loops tight. Use vise grips to crimp
Tack weld clip (6) to overturn rail to securely retain cable (5). Cable should not slip through
Install two lockpins (3) through grabhandle (2) and mounting bracket (1).