BRAKE PLUNGER ASSEMBLY REPLACEMENT/REPAIR - Continued
Adjusting sleeve must bottom on shoulder inside plunger. Threading adjusting screw too
far into adjusting sleeve will cause automatic adjuster not to function.
Install plungers in same location as removed and align keyways in anchor/adjusting
plungers with hole in plunger housings.
Install adjusting plunger assembly (10) in plunger housing (5).
Make certain grooves in pawl assembly end engage in adjusting sleeve grooves.
Position lockwasher (9) and pawl assembly (8) in plunger housing (5).
Tighten pawl assembly (8) to 15-25 lb-ft (20-34 Nm).