Share on Google+Share on FacebookShare on LinkedInShare on TwitterShare on DiggShare on Stumble Upon
Custom Search
 
  
 
TM 9-2330-394-13&P
CENTER CROSSMEMBER REPLACEMENT - Continued
0119 00
INSTALLATION, MTVT
CAUTION
Do not overtighten plastic cable ties on a cable. Overtightening can damage cable.
Failure to comply may result in damage to equipment.
NOTE
Left and right sides of center crossmember are installed the same way. Right side
shown.
Bundle any excess cable in a loop, and secure excess cable on center crossmember
with plastic cable ties. Excess cable should not exceed two feet (61 cm).
Install plastic cable ties as required.
Steps (1) through (3) require the aid of an assistant.
1.
Position center crossmember (3) on support link (2) with four bolts (1).
Tighten four bolts (1) to 135-165 lb-ft (183-223 Nm).
2.
3.
Perform steps (1) and (2) on left side of center crossmember (3).
0119 00-3


 


Privacy Statement - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business