TM 9-2350-222-10-2
OPERATE BOOM (PERFORM AFTER HOISTING OPERATIONS) - Continued'
CAUTION
Do not operate BOOM CONTROL lever (Q)
and WINCH CONTROL lever (D) at the same
time or damage may occur to boom linear
actuating cylinder.
13. Move BOOM CONTROL lever (Q) down to bring
boom down, stopping every one to two feet to use
WINCH CONTROL lever (D) to take up slack in
winch cable, until boom is about one foot from each
travel lock (F).
14.
Move BOOM CONTROL lever
(Q) down to FINAL STOW
position. Release lever when
boom (M) rests in both travel
locks (F).
15.
Close retainer (G) on both boom
travel locks (F).
16.
Turn locking handle (E) clockwise
until retainer (G) is tight.
17.
Push locking handle (E) down.
18.
Move WINCH CONTROL lever
(D) up to reel in cable slack.
Release lever w hen cable is snug.
TA132448
2-308