TM 9-2350-222-10-3
TROUBLESHOOTING - Continued
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
1.
ENGINE DOES NOT CRANK WHEN STARTER SWITCH IS PRESSED -
Continued
Step 3. Check to see if battery water level is above top of plates (page 2-85).
If water level is low, add distilled water (or clear water if distilled
NOTE
Make sure FUEL PUMPS switch is ON.
Step 4. Slave start vehicle (page 2-609).
a. Allow engine to run 15 minutes to charge batteries
b. If engine does not start or batteries do not charge, notify organiza-
tional maintenance.
2. ENGINE CRANKS BUT DOES NOT START
CAUTION
Do not push manifold heater switch (A) while operating
purge pump handle (B) in step 1. This will damage the
intake manifold.
Step 1. Pump purge handle (B) until you feel back pressure.
Air will be purged from fuel lines.
Step 2. Start engine (page 2-205).
If engine does not start, go to step 3.
TA252938