C10, TM 9-2350-230-12
Figure 2-10. Driver's switch panel
TABLE 2-4. AMPHIBIOUS OPERATION
STEP
PROCEDURE
REFERENCE
PREPARING VEHICLE FOR AMPHIBIOUS OPERATION
1
Perform before-operation preventive-maintenance checks and services
WARNING: The crew should be thoroughly trained on procedures
for evacuating the vehicle in water prior to amphibious operation.
CAUTION: 1. Vehicle must be combat loaded with equipment
App. II
correctly stowed and secured to achieve proper balance in water
2. Attach tow cable to front or rear towing shackles to
facilitate towing in case of power failure. Secure center portion of
cable to vehicle to prevent drag or entanglement.
2
Be sure driver's escape hatch and drain/access plugs on hull bottom
are secured. On vehicles equipped with exhaust plume diffuser, pull
pin and turn diffuser upside down (off the exhaust outlet) whenever
vehicle is to be operated with barrier erected.
3
Erect and secure surfboard and barrier. Make certain surfboard cavity
drain cover is in place. Remove covers from front bilge pump outlets
& 2-12. 1
CAUTION: Traverse gun-launcher approximately 90 mils to the
left of driver's hatch cover, prior to swimming, so driver will have
additional clearance in evacuating vehicle if necessary.
2-15