TM 9-2350-277-10
BREAK/JOIN T150 TRACK -- Continued
0092 01
WARNING
Always wear eye protection when using a hammer. Eye injury may result if metal chips
contact eyes.
6.
Install the end connector on the outside track shoe pins. Get the angle needed to allow the end connector to fit on the
track shoe pins. Tap on the end connector close to the alignment tool. Remove the track alignment tool. Tap the end
connector fully onto track shoe pins. Make sure it touches both track shoe bodies.
7.
Install inside end connector. Only a slight amount or no leverage is needed to install the second connector if the outside
end connector is already installed.
0092 01-9
Change 4