TM 9-2350-277-10
BREAK/JOIN T150 TRACK -- Continued
0092 01
8.
Once the end connector is installed halfway on the inside of the track assembly, remove the track fixture and track
alignment tool. Finish installing the end connector all the way on the track shoe pins until it touches the track shoe body.
WARNING
Not getting the bolt tight enough may result in death to personnel and damage to equipment if
the end connectors fall off during movement of the vehicle. Use the wrench extension over the
breaker bar to achieve more leverage when tightening the end connector bolt.
NOTE
Mark the location of the end connectors so unit maintenance can torque them properly. Take
the vehicle to unit maintenance as soon as possible to have the end connector bolts torqued to
the proper value.
NOTE
Move vehicle far enough to position end connectors that need to be tightened on top.
9.
Secure both end connector bolts using the socket wrench handle and wrench extension to get enough torque until you
can get it to unit maintenance to torque it properly. Mark the end connectors you have loosened and retightened so unit
maintenance can tighten to the right torque value. Fill out DA Form 2404 or DA Form 5988-E to notify unit maintenance.
0092 01-10
Change 4