TM 9-2590-209-14&P
f. Install two caps to mounting bracket.
Secure
4-36.
with four screws and lock-washers (view D).
NOTE
g. Install rear guard, and secure with four screws,
lockwashers, and washers (view C).
Procedures for both left and right
sides are the same.
h. Install front guard, and secure with two screws,
lockwashers, and washers (view B).
a. Position cylinder assembly on mounting bracket
(view F).
i. Install top guard, and secure with four screws,
b. Install pin securing pushbeam to ram assembly.
lockwashers, and washers (view B).
Secure with screw, lockwasher, and lock (view F).
c. Connect reducer, elbow, two nipples, elbows,
j. Install four screws securing top guard (view A).
seal assembly, and elbow to bottom of cylinder assembly
(view E).
d. Connect reducer and elbow to top of cylinder
assembly (view E).
e. Connect two hose assemblies to cylinder
assembly (view E).
Section X. MAINTENANCE OF BLADE AND CYLINDER MOUNTING BRACKETS
f. Remove three setscrews and nuts on mounting
4-37. Description. Two mounting brackets support
bracket (view A).
the blade, pushbeams, tilt arms, hydraulic cylinders, and
carrying hooks on the front of the vehicle.
The
securing guard to mounting bracket (view A).
pushbeams and tilt arms pivot on the mounting brackets
h. Remove three screws, lockwashers, and
when the hydraulic cylinders are extended or retracted.
washers securing guard to mounting bracket, and
remove guard (view A).
4-38.
i. Install lifting eye to mounting bracket and secure
with bolt (view B).
a. Remove cylinder assembly and guards from
j. Attach cable and hook to lifting eye, and take up
slack (view B).
b. Remove pushbeam from mounting bracket (para
pin to mounting bracket, and remove pin (view B).
c. Remove tilt arm from mounting bracket (para 4-
l. Remove mounting bracket from vehicle (view B).
25).
d. Remove carrying hooks from mounting brackets
securing guard, and remove guard (view A).
4-26