TM 9-2590-209-14&P
c. Rest hydraulic pump assembly mounting
g. Connect electrical lead to magnetic clutch (view
bracket on transmission bracket. Align and install power
A).
takeoff assembly right-angle drive sprocket with drive
h. Connect two hydraulic hose assemblies to
sprocket spline in transmission (view B).
hydraulic pump assembly, and secure with four flanges,
and secure power takeoff assembly to transmission
i.
(view B).
e. Install two screws, lockwashers, washers, and
I. Install transmission shroud, and close rear grille
nuts securing hydraulic pump assembly mounting
doors. See TM 9-2350-215- 20 (M60, M60A1), TM 9-
bracket to transmission mounting bracket (view A).
2350-257-20-1 (M60A1 RISE), or TM 9-2350-253-20-1
(M60A3).
f. Remove hoist and rope from power takeoff
assembly.
Section XVII. MAINTENANCE OF POWER TAKEOFF RIGHT-ANGLE DRIVE
d. Remove two screws, lockwashers, washers,
4-71. Description. The power takeoff right-angle drive
and nuts securing hydraulic pump assembly mounting
is mounted in the vehicle as an integral part of the pump
bracket to transmission mounting bracket (view A).
and drive assembly. The pump and drive assembly is
composed of:
(1) hydraulic pump assembly, (2)
e. Disconnect electrical lead from magnetic clutch
magnetic clutch, and (3) power takeoff right-angle drive.
(view A).
CAUTION
f. Attach rope and suitable hoist (minimum
capacity 250 lb), and apply tension on rope to support
Do not remove drain plugs or disconnect
weight of unit (view B).
tubes while engine is running to prevent
damage to hydraulic pump.
g. Remove five screws, lockwashers, and
washers securing power takeoff assembly unit to
transmission (view B).
a. Disconnect lines carefully to relieve pressure.
h. Pull power takeoff assembly away from
transmission to disengage right-angle drive from drive
sprocket in transmission (view B).
b. Open rear grille doors, and remove
transmission shroud. See TM 9-2350-215-20 (M60,
i. Apply lift with hoist and remove power takeoff
M60A1), TM 9-2350-257-20-1 (M60A1 RISE), or TM 9-
assembly and gasket from transmission (view B).
2350-253-20-1 (M60A3).
Remove hoist and rope.
c. Remove eight screws, lockwashers, four
flanges, and two packings securing hydraulic hose
assemblies to hydraulic pump assembly, and disconnect
hoses (view A).
a. Remove six nuts, washers, and studs securing
hydraulic pump assembly to magnetic clutch, and
remove pump assembly.
4-45