TM 9-2590-209-14&P
(3) Remove nut (3) securing rod assembly (2) to
arm (4), and remove rod assembly.
(8), and remove cover and gasket.
(4) Remove nut (5), lockwasher (6), and washer (7)
securing arm (4) to shaft (8), and remove arm and key
(15) Remove four screws (1) and lockwashers (2)
(9).
securing control valve guard cover (3) and gasket (4).
(5) Remove nut (10), lockwasher (11), and washer
(12) securing shaft (8) to arm (13), and remove shaft and
assembly (2) to link assembly (3).
key (9).
(17) Pull rod assembly (2) through guard (13)
(6) Remove nut (14) securing arm (13) to rod
(toward torsion bars), and remove rod assembly.
assembly (15), and remove arm.
(18) Remove cotter pin (4) and pin (5) securing
(7) Remove nut (16) securing rod assembly (15) to
clevis (6) to control valve located in manifold.
lever (17), and remove rod assembly.
(19) Remove bolt (7) securing rod (8), and remove
(8) Remove nut (18), lockwasher (19), washer (20),
rod assembly (11).
securing lever (17) to shaft (22) and remove lever (17)
and key (21).
(20) Remove rod end (10) and two nuts (9) from rod
(8).
lockwashers (17) securing cover (16) and gasket (15) to
(21) Remove bolt (12) securing link assembly (3) to
guard, and remove cover and gasket.
guard and remove link assembly.
(10) Remove nut (1) securing rod assembly (2) to
NOTE
arm (3).
Perform following steps only if required.
(11) Remove nut (9) securing rod assembly (2) to
bracket (10), and remove rod assembly.
(2), and lockwasher (3) from guard (4).
(12) Remove nut (11) securing rod assembly (12) to
bracket (10).
(23) Remove two screws (5) and lockwashers (6)
securing guard (4) to front right torsion bar housing.
(13) Remove four screws (13) and lockwashers
Remove guard.
(14) securing bracket (10) to guard, and remove bracket.
4-50