TM 9-2590-209-14&P
CHAPTER 6
REPAIR INSTRUCTIONS
Section I. REPLACEMENT OF EMERGENCY LIFITING CABLE
6-1.
Description. Two emergency lifting cables are
attached to the moldboard of the blade assembly by
stowage clamps. Stowage clamps secure each cable
length to the moldboard.
6-2.
Cable Stowage Clamp Assembly.
(1) Lower blade assembly to ground.
(2) Stop vehicle engine and apply parking
brake.
(3) Loosen locknut and remove eyebolt, nut,
lockwasher, and clamp.
(1) Position loop of cable over.
(2) Place clamp over cable.
Figure 6-1.
Removal or installation of eyebolt hole
(3) Tighten eyebolt and locknut.
cable stowage clamp
6-3.
Emergency Lifting Cable.
(1) Lower blade assembly to ground.
(2) Stop vehicle engine and apply parking
brake.
(3) Remove four clamps from cable.
(4) Remove cable and tube from moldboard.
Figure 6-2.
Removal or installation of emergency
lifting cable.
6-1