3-103. Removal and Installation. Refer to figures
3-100. Replacement of Emergency Lifting Cables.
3-44 and 3-45 for removal and installation instructions
Follow the alphabetical sequence of views for removal
for removal and installation instructions. Follow the
and the numerical sequence of views for installation.
applicable sequence of views for removal and the
numerical sequence of views for installation.
instructions.
3-102. Replacement of Carrying Hooks and Shafts.
PLACE MOLDBOARD IN STOWED POSITION.
NOTE. AS AN AID IN SUPPORTING CUTTING EDGE
WHEN REMOVING, LEAVE BOLT IN EACH END OF
WARNING: BE SURE MOLDBOARD IS SECURED
BLADE UNTIL OTHERS HAVE BEEN REMOVED. ON
BY CARRYING HOOKS BEFORE PROCEEDING
INSTALLATION, POSITION CUTTING EDGE ON
WITH REMOVAL.
MOLDBOARD AND ASSEMBLE DOLTS IN EACH
END AND ONE AT CENTER TO SUPPORT WEIGHT
REMOVE/INSTALL SHOULDER BOLTS, NUTS AND
AND FACILITATE ALINEMENT FOR REMAINING
DOLTS.
(BLADE) TO THE MOLDBOARD.
REMOVE/POSITION CUTTING EDGE.
AT 19682
Figure 3-42. Removal or installation of moldboard cutting edge.
3-58