(3) Install diaphragm (4) on base (3), aline
holes in diaphragm and base, and then
position cover (2) on diaphragm and aline
holes in cover with other holes.
(4) Install three screws (1) in cover (2).
Tighten screws to 22 to 30 pound-inches.
g. Checkout. Pull poppet (6) up and down several
times. The poppet shall move freely, without
sticking or binding.
h. Installation. Refer to para 5-19.f.(12) for pilot
assembly installation instructions.
5-21. CONVERTER ASSEMBLY TESTING INSTRUCTIONS.
This task covers:
Tools, Special Tools and Test Equipment
Test Fixture, F65-0-4273
Pressure Gage, 0-10 psig
Special Environmental Conditions