ARMY TM 9-2805-259-14
AIR FORCE TO 38G2-89-54
NAVY NAVFAC P-8-615-12E
4-32.
Magneto and Gear (cont).
c. Installation (Gear). (figure 4-25)
Install gear (28) and secure with washer (27) and retaining ring (26).
NOTE
Before installing magneto rotate magneto gear clockwise unti spark is obtained from number one
part of magneto housing.
d. Installation. (figure 4-25
(1) Rotate starter rope pulley (29) until both rockers on number one (1) cylinder (30) dose, and stop when timing
mark on camshaft gear (31) is present.
(2) Hold end of high tension wire from number one (1) terminal of magneto (12) 1/8 inch from magneto case.
Turn magneto gear clockwise until magneto impulses and spark occurs. Turn magneto gear (28) counter
clockwise until magneto gear (28) timing mark and camshaft gear (32) timing mark are aligned. Install
magneto (12) and gasket (29) (3)Install screw (22), washer (23), and lockwasher (24).
(4) Position manual choke bracket (21) and secure manual choke bracket (21) and magneto (12) with bolt (17),
washer (18), lockwasher (19) and nut (20).
(5) Install lead (11) as tagged and secure with assembled screw and washer (10).
(6) Position lead (11) on magneto (12) and tighten screw (9).
(7) Install intake manifold elbow (15), and gasket (16) and secure with two assembled screws and washers
(14).
(8) Tighten damp (13).
(9) Install high tension cable (8) as tagged, and tighten connector nut (7).
(10) Install high tension cable (6) as tagged, and tighten connector nut (5).
(11) Install high tension cable (4) as tagged, and tighten connector nut (3).
(12) Install high tension cable (2) as tagged, and tighten connector nut (1).
Change 4 4-56