ARMY TM 9-2805-259-14
AIR FORCE TO 38G2-89-54
NAVY NAVFAC P-8-615-14E
4-46. Carburetor (cont).
b.
(1) Remove screw (1) a nd washer (2) and remove governor control rod (3).
WARNING
Do not smoke or use an open flame in the vicinity of gasoline vapors.
(2) Loosen fitting nut (4) on fuel line (5).
(3) Loosen screw (6) and remove choke lever (7) from choke rod (8).
(4) Remove screw (9), washer (10) and nut (11) securing manual choke bracket (12).
(5) Remove manual choke (13) and spring (14) from manual choke lever (15).
(6) Remove two nuts (16), Iockwashers (17) and flat washers (18) and remove carburetor (19) and
gasket (20).
WARNING
Drycleaning solvent PD-680 used to clean parts is potentially dangerous to personnel and
property. Avoid repeated and prolonged skin contact. Do not use near open flame or
excessive heat. Flash point of solvent is 100F.-138F. (38C.-60C.).
(7) Clean outside of carburetor (19) with drycleaning solvent and dry thoroughly.
(8) Inspect carburetor (19) and replace if carburetor body is cracked or otherwise damaged.
c. Installation. (figure 4-43)
(1) Ensure all gasket surfaces are clean and free of old gasket material.
(2) Install carburetor (19) and gasket (20) and secure with two nuts (16), Iockwashers (17), and flat
washers (18).
(3) Install spring (14) and manual choke (13).
(4) Install manual choke bracket (12) and secure with screw (9) and washer (10) and nut (11).
(5) Install fuel line (5) and tighten fitting nut (4).
(6) Position choke lever (15) in the full open position and install choke lever (7) in horizontal position and
tighten screw (6).
(7) Install governor control rod (3) and secure with screw (1) and washer (2).
4-92