ARMY TM 9-2805-259-14
AIR FORCE TO 38G2-89-54
NAVY NAVFAC P-8-615-14E
b. Installation
This task covers:
a. Removal
INITIAL SETUP
Equipment Condition
Tools
Materials/Parts
(1) Remove two screws (1) and washers (2) securing oil pan shroud (3) to fan housing (4).
NOTE
The engine mounts, oil pan baffle, and control rod are installed on fan housing and do not
have to be removed to remove fan housing assembly. Refer to unit maintenance in
Chapter 4 for removal and installation of these items.
(2) Remove six assembled screws and washers (5) and fan housing plate (6) and remove fan housing (4).
WARNING
Drycleaning solvent PD-680 used to clean parts is potentially dangerous to personnel and
property. Avoid repeated and prolonged skin contact. Do not use near open flame or
excessive heat. Flash point of solvent is 100F.-138F. (38C.-60C.).
(3) Clean fan housing (4) with drycleaning solvent, and dry thoroughly.
(4) Inspect fan housing and replace if cracked or otherwise damaged.
b. Installation. (figure 5-2)
(1) Install fan housing (4) and fan housing plate (6) and secure with six assembled screws and washers (5).
(2) Install two screws (1) and washers (2) and secure oil pan shroud (3) to fan housing (4).