TM 9-3405-205-14 & P5
LUBRICATION CHART
ITEM NO
INTERVA
ITEM& INSTRUCTIONS
RECOMMENDED LUBRICANT
L
1
Weekly
Variable Speed Sheaves - oil male hubs
SAE No. 10
2
Weekly
SAE No. 10
3
Monthly
Variable Speed Adjusting Screw
Fiske Co., Lubriplate
No. 630A
4
Monthly
Band Tensioning Screw
Fiske Co., Lubriplate
No. Lubriplate
5
Monthly
Upper Wheel Slide
Fiske Co., Lubriplate
No. 630A
6
Monthly
Variable Speed A
SAE No. 10
7
Monthly
Transmission. Fill Through Fill Plug (drain and
Mobil Vactra No. 1
Flush ever six months)
8
Monthly
Upper Wheel Tilt Bracket Pivot Screws and
SAE No. 10
adjusting screw
9
Monthly
Table Trunnion Surfaces, clean & regrease
Fiske Co., Lubriplate
No. 630A
10
Monthly
SAE No. 10
11
Monthly
Guide Post & Guide Post Clamp Screw
SAE No. 10
12
6 Months
Fiske Co., Lubriplate
No. 630A
LOCATION PLANNING
Caution: Lift machine with fork lift truck under base. Do not lift through the throat opening. Net weight is 1100
lbs. (498.96kg), approximately. The machine should be located so that space is allowed for easy feeding and
removal of material. Clearance should also be allowed behind the machine for servicing and in front for the
RECEIVING
Remove all protective coverings, crating, etc. carefully. Inspect the machine for broken or damaged parts. Any evidence
of damage in transit should be reported
immediately. Four (4) holes are provided in the base for anchoring the machine to the floor.
Level the table and check to see that post is square to the table. Connect the leads of the line circuit into
the starter on the back of the machine and check for proper direction of rotation as follows:
1. into low range on transmission. To do this, manually rotate the bottom wheel, at the same time move shift lever to
the left detent position.
2. start button to start main drive .motor and check rotation. The lower wheels should rotate clockwise. not,
disconnect machine from power source and change any two incoming leads in the starter usually mounted on the
rear of the column of machine. Install a saw band and check to see that the band touches upper and lower
backup bearings in saw guide and is centered on both top and bottom wheels. If it is not centered, see section on
band saw lineup for proper
5