SIDE-MOUNTING MITERING ACCESSORY
Set up this attachment as shown in the drawing, making sure that the mitering bar
is in even contact with the table surface. Use a combination square in the table slot
as a basis for alignment and setting the mitering bar at various angles.
When not in use, swing the attachment up, to the right and around on the slide rod
so that it hangs below the table.
RlP FENCE
To set up this accessory be sure to square
the fence so that it is in line with the table
slot. Also make sure that the machine is
in proper alignment as described in the
Installation Chapter.
In making a long cut, check to be sure
that the saw band used is not worn on one
side. This will cause the work to wander
relative to the rip fence guide.
22