CONTOUR SAWING ATTACHMENT & PROCEDURES (Air powered table only)
The contouring attachment permits the operator to guide a workpiece through intricate contours
by means of a single handwheel controlling a gear train, sprocket, chain and holding fixture. The
control handwheel at the right front of the table drives the sprocket and chain which turns the
work being cut.
The sprocket work holding fixture will take round workpieces to 11-1/4 in. diameter or rectangle shapes
to 8 x 11 inches. Place workpiece in center of fixture, hook holding chain into chain connectors
and tighten clamp screw to hold work solid. Place drive chain around sprocket at rear of table and
work fixture. Connect chain with quick lock provided, shortening chain loop enough to bring work
into sawing position with table in forward position.
Do not feed the work so rapidly that the saw band twists or bows. Follow recommendations on,
job selector for band speed, feed pressure and coolant application.