PROTRACTOR WORK STOP AND ALIGNING GAGE (Air powered table only)
(1)
To set up, lock T-shaped slide on bottom of base plate in table T-slot.
(2)
Set stop on table slide bar in a position that will prevent saw band from sawing into
miter head.
(3)
Adjust miter head for angle cutting by releasing clamp stud. The protractor plate is
calibrated to 45 degrees.
(4)
Adjust gage rod to control length of cut by loosening thumb screw and sliding rod
to its correct position. Turn selector switch on control panel to straight ( if
SERVO-CONTOUR is used).
Protractor work stop.
This accessory is
especially adapted
For production cut-off
and angle cut-off
operations.
33(34 blank)