NUMBER
ENGINEERING ADJUSTMENT SUMMARY
120789-2
MODEL DBW - 15
FIG. 6
FINAL JAW ALIGNMENT
A weld must be made in 1" x0.035 ga. Imperial band in order to check the
final alignment. The finished weld must be within 4% of the band gage.
The both edge of the hand must be straight within (0.004" in 4" measured 2"
on either ride of the weld. To make this weld:
Set the jaw upset force knob to its maximum wide position.
1.
Set the initial jaw gap by adjusting the position of the weld lever.
2.
It must be set to the line indicating the widest width.
Make the final jaw alignment adjustment as required to result
3.
in the tolerances listed.
Prepared by: Roger Harris
Approved:
Date: 7-31-69
H-44