TM 9-3405-213-14&P
SPECIFICATIONS - Continued
LIFT:
A positive lift of the blade on each non-cutting stroke is accomplished hydraulically.
SINGLE LEVER
Single lever controls all operating phases of machine. Governs rapid traverse of saw guide up
CONTROL:
and down, clutch engagement, and rest positions.
ADJUSTABLE
At the finish of the cut a valve releases hydraulic pressure to move the control lever upward.
AUTOMATIC
Clutch is disengaged and saw frame rises to its highest position after each cut. Knockout may
be
KNOCKOUT:
adjusted to limit the cut to any desired depth and also to limit the height to which the saw guide
will rise.
BLADE HOLDERS:
Of special design hold the blade rigidly in perfect alignment and proper tension for accurate
cutting.
DOUBLE SWIVEL
Grip stock on both sides of blade. Rear vises bolted to table, front vises quick acting, engage
VISES:
slots in table plates. Rear vise jaws fitted with steel plates. Height of jaws 8". Table opening
permits chips to fall into pan for easy removal. Vises that swivel for cutting angles up to 450 are
furnished as standard equipment. Manual overhead clamp is furnished for clamping bundled
material.
TABLE PLATES:
Two special cast nickel iron table plates on machine are replaceable in case of damage or wear.
COOLANT PUMP:
Simple constant pressure gear pump supplies coolant through two flexible steel hose
connections to saw blade. Pump equipped with relief valve to control flow of coolant. Strainer in
main chip pan and screened removable chip pan in coolant pump protect pump from floating
chips.
LUBRICATION:
All gears run constantly in oil. - Hydraulic pumps self-oiling. Wick oilers provided on saw slide,
connecting rod bearings and other bearing points.
CLUTCH:
Twin Disc; held in engagement by hydraulic pressure.
LENGTH GAUGE:
Adjustable to permit duplicating cuts of the same length, without resetting.
BEARINGS:
All main bearings and revolving bearings Bronze bushed.
MOTOR:
5 HP 1200R PM.
DRIVE:
Direct from motor to main drive pulley of machine through 2 step Poly Vee Belt Drive. Motor
attached to heavy cast iron platform hinged to rear of machine base. Motor platform adjustable
for belt take up. All belts completely guarded with safety guard easily removable.
DIRECTION
Direction plates are attached to each machine which will assist the operator in selecting the
PLATES:
correct cutting speed and feeds.
3