TM 9-3405-215-14&P
90 SAW BAND GUIDE BRACKETS
NO. 2 CUT-OFF & RIPPING (Side Mount)
Make sure mitering bar is in even contact with table
The 90 degree saw guide brackets permit cutting
surface. Place a combination square in table slot to
material greater in length than the machine's regular
check alignment and set mitering bar at various angles.
throat capacity. Mount brackets and correct saw guides.
See Fig. 28. Install band so it is twisted 90 degrees
when passing through inserts. Operate machine at
When not in use, swing unit up, to the right, and down on
speeds under 1500 fpm (450 m/min).
slide rod so it hangs below table.
FIG. 30. NO. 2 CUT-OFF AND RIPPING (SIDE
MOUNT).
FIG. 28. 90 SAW SAND GUIDE BRACKETS.
UNIVERSAL VISE
RIP FENCE
Applies work-holding pressure needed for accurate
Install by squaring fixture so it is in line with table slot.
production cut-off work between 0-45 degrees.
An
Be certain band is not worn on one side before
adjustable cut-off gage assembly mounts in a T-slot on
attempting a long cut. This will cause work to wander
the table's left side to allow duplicate cut-off operations for
relative to rip fence guide bar. See Fig. 29.
production runs. Work is rapidly clamped and unclamped
by a lever-operated eccentric. Table T-slots allow vise to
be removed quickly and easily. See Fig. 31.
FIG. 29. RIP FENCE.
FIG. 31. UNIVERSAL VISE.
19