OPERATION (Cont'd)
selected. The feed may be changed whether the
SELECT SPEED
machine is running or idle. A feed direction control is
Sixteen ram speeds are obtained by positioning the
provided at the crossrail. Setting this control away from
range and speed levers. Four speeds are available in
the machine, feeds the table toward the operator.
each of the four range positions. Always check speed
Setting the control in the opposite direction, feeds the
plate on machine for safe combination of speed and
table away
stroke length.
from the operator. The feed is disengaged by setting
Always disengage clutch when shifting gears.
the control in the midway position.
When cleaning chips off the vise and table, always
SELECT FEED
brush away from and not toward the frame or on the
The feed selector controls the amount of feed. A
ways, to prevent chips from getting inside the machine
plunger locks and indicates the feed
or scoring the ways. Do not use compressed air.
Figure 3.
TABLE OF DIMENSIONS
Subject to change without notice
Size Machine
D
E
F
G
H
I*
J
K*
L*
M
N
O
P
Q
R
16" Plain T.R.
3"
12"
73"
57"
48"
18"
21"
29"
-
42"
16"
0"
3"
1"
2"
16" T. R
3"
12"
73"
57"
48"
18"
21"
29"
45"
51"
16"
0"
3"
1"
2"
16" Ind.
4"
14"
83"
60"
48"
21"
24"
32"
53"
59"
19"
2"
4"
1"
3"
16-20" Ind.
4"
14"
85"
60"
48"
21"
24"
32"
53"
59"
21"
2"
4"
1"
3"
20" Ind.
4"
14"
93"
61"
48"
21"
24"
32"
55"
61"
26"
2"
4"
1"
3"
20-24" Ind.
4"
14"
95"
61"
48"
21"
24"
32"
55"
61"
28"
2"
4"
1"
3"
24" Ind.
5"
16"
105"
68"
56"
25"
28"
38"
68"
75"
26"
3"
5"
1"
3"
28" Ind.
5"
16"
108"
68"
56"
25"
28"
38"
68"
75"
28"
3"
5"
1"
3 "
32" Ind.
5"
16"
121"
68"
56"
25"
28"
38"
68"
75"
37"
3"
5"
1"
3"
32" Hvy. Ind.
5"
16"
122"
73"
56"
31"
34"
44"
75"
85"
35"
3"
6"
1"
3"
*If hold down bolts are to be permanently located before machine is received, it is necessary to obtain
certification of dimensions I, K and L.
5