J. I. C. INSTALLATIONS
Part No. W 260 Pump Set
(Natural gas, gasoline, diesel compressed air, hydraulic motor, alternate power source, Etc.)
For J. I. C. Installation -where power connections are limited or where an Alternate or Auxiliary (other than electric)
power is used, the auxiliary pump is provided. The pump requires no electricity but operates off of the Main Idler Shaft and
may be used directly on all model CHY-2 machines. For older machines and CHX machines the idler set # W342 must be
used. When ordering be sure to state model number and serial number of Honing Machine to be converted.
A neoprene impeller is provided which is compatible with most Honing fluids and is resistant to the deterioration action of
abrasives and other stray particles in suspension. A Buena N impeller is available for use with special honing fluids or
fluids containing strong solvents, Etc.
INSTRUCTIONS
1.
Disregard other pumping system provided and use J. I. C. pump in place of the regular pump outlet with fitting
provided using instructions supplied.
2.
Start Honing Machine and use oil in the ordinary manner.(NOTE : If machine has stood pump should prime
immediately and oil should flow. If slow prime, impeller is swollen or worn and a new impeller should be installed.
Part No. W 301 Regular Impeller
Part No. W 300 Buena N Impeller
3.
For high speed operation be sure screws to shaft are very tight. Do not allow oil to heat excessively at the pump.
Attach an ordinary relief or flow control to the line if required (for high production use).
67