TM 9-4110-246-14
TO 40R7-5-10-1
CEILING PANEL ASSEMBLY (1, typical) . Provides roof insulation for refrigerator unit . Ceiling structure
consists of left ceiling panel assembly, right ceiling panel assembly, and three center ceiling panel assemblies.
CORNER PANEL ASSEMBLY (2, typical) . Provides corner structural support and insulation for unit .
Refrigerator has four corner panel assemblies that are part of the wall structure.
STANDARD WALL PANEL ASSEMBLY (3, typical) . Provides side structural support and insulation for
refrigerator unit . Refrigerator has eleven standard wall panel assemblies.
EVAPORATOR PANEL ASSEMBLY (4, typical) .
Part of
refrigerator wall structure that allows mounting of
refrigeration cooling equipment (not supplied) . Unit has two evaporator panel assemblies.
FLOOR PANEL ASSEMBLY (5, typical) . Provides base structural support and insulation for unit . Floor
structure consists of left floor panel assembly, three center floor panel assemblies and right floor panel
assemblies.
DOOR FRAME PANEL ASSEMBLY (6) . Provides mounting for refrigerator walk-in door and contains
refrigerator electrical wiring and components.
WALK-IN DOOR ASSEMBLY (7) . Provides access to and from refrigerator unit.
1-7.
EQUIPMENT DATA.
Length ....................... ................................ .............
16 feet, 7 inches (5055 mm)
Width ........................ ................................ ..............
12 feet, 9 5/8 inches (3903 mm)
Height ..................... ................................ ...............
7 feet, 5 3/4 inches (2280 mm)
Capacity (Volume) ............ ................................ ......
1900 cubic feet (53.80 cu.m)
Electrical Requirements ...... ................................ ....
125V ac, 50/60 Hz (interior vapor proof
light and exterior pilot light)
Weight ................................ ................................ ....
4,140 lbs (9,108 Kgs)
Section III . TECHNICAL PRINCIPLES OF OPERATION
1-8.
The ceiling, wall, and floor panel assemblies are wooden-framed, filled with densely-packed insulating foam, and
covered with sheet metal . This provides an insulating barrier which helps maintain temperatures inside the
refrigerator . Gasket panels are used between the interlocking refrigerator panels to seathe unit.
l
A thermometer mounted inside displays the refrigerator's inside temperature.
The external power receptacle is connected to the light switch, vapor proof light, and pilot light . The switch is
mounted inside and controls the inside vapor proof light . The pilot light is outside and indicates when the inside
vapor proof light is on . This circuit requires a 125V ac input to power the lights.
1-3/(1-4 blank)