TM 9-4110-256-14
NOTE
Mounting hardware is not supplied with coil. Screw and lockwasher must be retained for use
during installation of coil.
(2) Remove screw (4), lock washer (5), data plate (6), and coil (2).
(3) Cut wire leads (7) if necessary and remove grommet (8).
c. Installation.
(1) Push wire leads (7) through grommet (8) and install grommet into coil (2).
(3) Install coil (2), data plate (6), lock washer (5), and screw (4).
(4) Using tags and wiring diagram (fig. 1-4), connect tabs (1). Remove tags.
Figure 4-37. Solenoid Valve (Liquid Line)
NOTE
FOLLOW-ON MAINTENANCE:
Connect power and put unit back into service.
4-89