TM 9-4120-370-14
TO 35E9-229-1
Determine length.
a.
b. Fabricate input power cable in accordance with Figure 422.
LENGTH - TO BE DETERMINED
MS3106R24-22S
(PI) CONNECTOR
I
POWER SUPPLY
--
LINE
A
--
8 AWG WIRE
208 VOLT, 3 PHASE
400 HERTZ
--
LINE
A
--
8 AWG WIRE
(F36T4-2S, F36T4-2SA,
--
LINE
A
--
8 AWG WIRE
AND F36T4-2SB)
OR 50/60 HERTZ
{
--
GROUND
--
8 AWG WIRE
(F36T-2S AND F36T-2SA)
TO J1 OR J18 CONNECTOR
Section Ill. LUBRICATION
4-13. GENERAL
The refrigerant compressor and its drive motor are hermetically sealed in a canister. The compressor crankcase has a
motor also have permanently lubricated, sealed bearings. No lubrication of these items is required.
4-14. MECHANICAL LUBRICATION
The only mechanical items which may require lubrication are the louvers in the conditioned air intake and discharge grilles
and the devices which operate the fresh air damper door. These points should be checked and lubricated, as necessary,
during preventive maintenance service. A few drops of light oil should be applied to pivot points, bearing surfaces, and
linkages to prevent oar eliminate stiffness or binding. Be sure to wipe off all excess oil with a cloth or paper towel. These
items are in areas of high volume airflow and excess oil will tend to attract and accumulate dust particles from the passing
air. Graphite may be used as an alternate lubricant during extreme cold weather operation.