TM9-4120-370-14
TO35E9-229-1
4-57. TERMINAL BOARDS (TB1 and TB2) -Continued.
Access
a.
(1) Using a screwdriver, remove ten screws and lock washers from junction box cover.
(2) Remove cover.
Inspection
b.
(1) Check terminal boards for loose or corroded terminals, cracks, and obvious damage, Replace if cracked
or broken.
(2) Check that wire leads are secure and properly located, (See Figure 4-20.)
Removal
c.
(1) Tag and disconnect wire leads.
(2) Using screwdriver and wrench, remove four screws and nuts from each terminal board,
d. Installation
(1) Using screwdriver and wrench, secure terminal boards to junction box with four each screws and nuts.
(2) See tags and wiring diagram (Figure 4-20) and connect wire leads,
(3) Remove tags,
(4) Using a screwdriver, secure junction box cover with ten screws and lock washers.
Follow-on procedure:
4-58. JUNCTION BOX HOUSING AND
COVER
Preliminary procedure:
a.
Access
(1) Using screwdriver, remove ten screws and lock washers from junction box cover.
(2) Remove cover.
b. Inspection
(1) Check that rover is not bent or punctured. Replace if damaged.