TM 9-4120-370-14
TO 35E9-229-1
GENERAL SUPPORT MAINTENANCE INSTRUCTIONS
Section I. REPAIR PARTS, SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT
GENERAL
6-1.
Repair parts are listed and illustrated in TM9-4120-370-24P. No special tools are required for general support mainte-
nance of the air conditioner. Maintenance, and Diagnostic Equipment (TMDE), and support equipment, includes standard
electrical test equipment, and standard pressure and vacuum gages, vacuum pumps, and servicing manifolds found in
any general support maintenance refrigeration facility.
Section Il. AUTHORIZED GENERAL SUPPORT MAINTENANCE ACTIONS
6 - 2 . GENERAL
The only items restricted to general support maintenance level by the Maintenance Allocation Chart (MAC) are the repair
of cracked or broken welds, repair or replacement of damper parts, blind nuts, nut plates, and lifting handles in casing,
and blind nuts and nut plates in base. However, general support maintenance may be called upon, at times, to perform
any or all of the MAC items listed for organizational and direct support maintenance for rehabilitation or overhaul of an
air conditioner.
DAMPER PARTS (MODELS F36T4-2S, F36T4-2SA, AND F36T-2S ONLY)
See paragraph 5-15 for actuating cylinders and condenser air outlet damper linkage.
Preliminary procedures:
1. Remove condenser outlet grilles. (See Para 426.)
2. Remove actuating cylinder access cover. (See para 420.)
NOTE
Figure 6-1 shows breakdown of
right side damper facing the rear. The left side parts are
installed opposite to breakdown shown.